Administrator Guide

ip host
Assign a name and an IP address to the host-to-IP address mapping table.
Z9000
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name Enter a text string to associate with one IP address.
ip address Enter an IP address, in dotted decimal format, to be mapped to the name.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced for the E-Series.
ip icmp source-interface
Enable the ICMP error and unreachable messages to be sent with the source interface IP address, such as the loopback
address, instead of the hops of the preceding devices along the network path to be used for easy debugging and diagnosis of
network disconnections and reachability problems with IPv4 packets.
Syntax
ip icmp source-interface interface
Parameters
interface Enter one of the following keywords and slot/port or number information:
● For a Management Ethernet interface, enter the keyword
managementethernet.
NOTE: When you configure the capability to enable the loopback IP
address to be sent for easy debugging and diagnosis (IP addresses of the
devices for which the ICMP source interface is configured), the source
IP address of the outgoing ICMP error message is modified, although
the packets are not sent out using the configured interface. Because the
management interface is configured without any parameters such as the IP
address, it is treated to the management interface of the primary unit or
the existing unit.
IPv4 Routing 595