Administrator Guide

debug arp
View information on ARP transactions.
Z9000
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, use the no debug arp command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information. The slot range is from
0 to 1. The port range is 0.
● For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
count value (OPTIONAL) Enter the keyword count then the count value. The range is from 1
to 65534.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was
2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Added the count option.
Usage
Information
To stop packets from flooding the user terminal when debugging is turned on, use the count option.
584 IPv4 Routing