Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the Primary or
Standby RPM).
duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with the speed set to
10/100.
management route — configures a static route that points to the Management interface or a forwarding
router.
stack-unit portmode
You can split a single 40G port into four-10G ports.
Z9000
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset. For the
Z9000, the range is from 0 to 7.
number Enter the port number of the 40G port to be split. The range is from 0 to 124 in
multiples of 4 (0, 4, 8, 12, ... 120 124).
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for dynamically fanning-out of interfaces on S6000. Introduced on
the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
546 Interfaces