Administrator Guide

show interfaces transceiver — displays the physical status and operational status of an installed
transceiver. The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial
number.
Z9000
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/port]
transceiver
Parameters
tengigabitethern
et
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
fortyGigE For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on theS6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Output augmented with diagnostic data for pluggable media.
7.7.1.0 Removed three fields in the output: Vendor Name, Vendor OUI, and Vendor PN.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage
Information
The following describes the show interfaces transceiver command shown in the following
example.
Line Description
Rx Power
measurement
type
Output depends on the vendor, typically either “Average” or “OMA” (Receiver
optical modulation amplitude).
Temp High Alarm
threshold
Factory-defined setting, typically in Centigrade. Value differs between SFPs and
SFP+.
Voltage High
Alarm threshold
Displays the interface index number used by SNMP to identify the interface.
Bias High Alarm
threshold
Factory-defined setting. Value can differ between SFP and SFP+.
Interfaces 537