Administrator Guide

AutoNeg: ON
Loopback: False
PowerDown: False
Isolate: False
DuplexMode: Full
Mode Status:
AutoNegComplete: False
RemoteFault: False
LinkStatus: False
JabberDetect: False
AutoNegotation Advertise:
100MegFullDplx: True
100MegHalfDplx: True
10MegFullDplx: False
10MegHalfDplx: True
Asym Pause: False
Sym Pause: False
AutoNegotiation Remote Partner's Ability:
100MegFullDplx: False
100MegHalfDplx: False
10MegFullDplx: False
10MegHalfDplx: False
Asym Pause: False
Sym Pause: False
AutoNegotiation Expansion:
ParallelDetectionFault: False
...
Related
Commands
show interfaces — displays information on a specific physical interface or virtual interface.
show interfaces stack-unit
Display information on all interfaces on a specific S-Series or Z-Series stack member.
Z9000
Syntax
show interfaces stack-unit unit-number
Parameters
unit-number Enter the stack member number. The range is from 0 to 7 for the Z9000.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
Example
Dell#show interfaces stack-unit 1
TenGigabitEthernet 1/1 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:4c:f2:82
Interfaces 533