Administrator Guide

Defaults Enabled.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
Usage
Information
This command is supported on C-Series, S-Series, and E-Series (TeraScale and ExaScale) 10/100/1000
Base-T Ethernet interfaces.
The no negotiation auto command is only available if you first manually set the speed of a port to
10Mbits or 100Mbits.
The negotiation auto command provides a mode option for configuring an individual port to forced-
master/forced slave after you enable auto-negotiation.
NOTE: The mode option is not available on non-10/100/1000 Base-T Ethernet line cards.
If you do not use the mode option, the default setting is slave. If you do not configure forced-master or
forced-slave on a port, the port negotiates to either a master or a slave state. Port status is one of the
following:
● Forced-master
● Force-slave
● Master
● Slave
● Auto-neg Error — typically indicates that both ends of the node are configured with forced-master or
forced-slave.
CAUTION: Ensure that one end of your node is configured as forced-master and one
is configured as forced-slave. If both are configured the same (that is, forced-master
or forced-slave), the show interfaces command flaps between an auto-neg-error and
forced-master/slave states.
You can display master/slave settings with the show interfaces command.
Example
(Master/Slave)
Dell(conf)# interface tengigabitethernet 1/1
Dell(conf-if)#neg auto
Dell(conf-if-autoneg)# ?
end Exit from configuration mode
exit Exit from autoneg configuration mode
mode Specify autoneg mode
no Negate a command or set its defaults
show Show autoneg configuration information
Dell(conf-if-autoneg)#mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
Dell(conf-if-autoneg)#
516 Interfaces