Administrator Guide

Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
Commands
management route — configures a static route that points to the Management interface or a forwarding
router.
speed (Management interface) — clears the FIB entries on a specified line card.
interface null
Configure a Null interface on the switch.
Z9000
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information
You cannot delete the Null interface. The only configuration command possible in a Null interface is ip
unreachables.
Example
Dell(conf)#interface null 0
Dell(conf-if-nu-0)#
Related
Commands
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
ip unreachables — enables generation of internet control message protocol (ICMP) unreachable
messages.
508 Interfaces