Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Documentation modified—added Management to distinguish from duplex
(10/100 Interfaces).
Usage
Information
This command applies only to the Management interface on the route processor modules (RPMs).
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the Primary or
Standby RPM).
duplex (Management) — sets the mode of the Management interface.
management route — configures a static route that points to the Management interface or a forwarding
router.
speed (Management interface) — sets the speed on the Management interface.
duplex (10/100 Interfaces)
Configure duplex mode on any physical interfaces where the speed is set to 10/100.
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to transmit only in one
direction.
full Enter the keyword full to set the physical interface to transmit in both
directions.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
Interfaces 501