Administrator Guide

ip igmp snooping fast-leave
Enable IGMP snooping fast-leave for this VLAN.
Syntax
ip igmp snooping fast-leave
To disable IGMP snooping fast leave, use the no igmp snooping fast-leave command.
Defaults Not configured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command.
Usage
Information
Queriers normally send some queries when a leave message is received prior to deleting a group from the
membership database. There may be situations when you require a fast deletion of a group. When you
enable IGMP fast leave processing, the switch removes an interface from the multicast group as soon as
it detects an IGMP version 2 leave message on the interface.
ip igmp snooping flood
This command controls the flooding behavior of unregistered multicast data packets.
Syntax
ip igmp snooping flood
To undo this configuration, use the no ip igmp snooping flood command.
Defaults Enabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
490 Internet Group Management Protocol (IGMP)