Administrator Guide

● When enabled, IGMP snooping Querier periodically sends general queries with an IP source address of the VLAN interface. If
it receives a general query on any of its VLAN member, it checks the IP source address of the incoming frame.
If the IP SA in the incoming IGMP general query frame is lower than the IP address of the VLAN interface, the switch
disables its IGMP snooping Querier functionality.
If the IP SA of the incoming IGMP general query is higher than the VLAN IP address, the switch continues to work as an
IGMP snooping Querier.
clear ip igmp snooping groups
Clear snooping entries from the group cache table.
Z9000
Syntax
clear ip igmp snooping groups [group-address interface | interface]
Parameters
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface
interface
Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on S-Series and Z–Series.
Usage
Information
IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results.
debug ip igmp snooping
Enable debugging of IGMP snooping packets on interfaces and groups.
Z9000
Syntax
debug ip igmp snooping [group address | interface]
● To disable debugging of IGMP snooping, use the no debug ip igmp snooping [group
address | interface] command.
● To disable all debugging, use the undebug all command.
Parameters
snooping Enter the keyword snooping to enable debugging of IGMP snooping.
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface
interface
Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
488 Internet Group Management Protocol (IGMP)