Administrator Guide

ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Z9000
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to IGMPv2.
3 Enter the number 3 to set the IGMP version number to IGMPv3.
Defaults 2 (that is, IGMPv2)
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Changed the default IGMP from version 2 to version 3. Introduced on the S6000-
ON
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
show ip igmp groups
View the IGMP groups.
Z9000
Syntax
show ip igmp groups [group-address [detail] | detail | interface [group-
address [detail]]]
Parameters
group-address (OPTIONAL) Enter the group address in dotted decimal format to view information
on that group only.
interface (OPTIONAL) Enter the interface type and slot/port information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
Internet Group Management Protocol (IGMP) 483