Administrator Guide

Version Description
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the system to
act as an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the system to
act as an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp ssm-map
To translate (*,G) memberships to (S,G) memberships, use a statically configured list.
Z9000
Syntax
ip igmp ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G) state, use
the ip igmp ssm-map std-access-list source-address command.
Parameters
std-access-list Specify the standard IP access list that contains the mapping rules for multicast
groups.
source-address Specify the multicast source address to which the groups are mapped.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
Version 9.5(0.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.7.1.0 Introduced on the E-Series.
Usage
Information
Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups.
You may not use extended access lists with this command. When you configure a static SSM map and the
router cannot find any matching access lists, the router continues to accept (*,G) groups.
Related
Commands
ip access-list standard — creates a standard access list to filter based on IP address.
Internet Group Management Protocol (IGMP) 481