Administrator Guide

Usage
Information
At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no
interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a configured AS number.
Example
Dell(conf)#router bgp 3
Dell(conf-router_bgp)#
set extcommunity bandwidth
Enables you to set extended community bandwidth.
Syntax
set extcommunity bandwidth
To disable extended community bandwidth, enter the no set extcommunity bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to enable extended community bandwidth. The
range is from 0 to 102400.
Defaults N/A
Command Modes ROUTER MAP
Command
History
Version Description
9.7(0.0) Introduced on the S-Series.
Usage
Information
A new policy command is introduced in order to attach the Link Bandwidth extended community only
to the prefixes that are received from a neighbor that satisfy the desired conditions. This command is
relevant for both inbound as well as outbound policy handling (for received prefixes). Also, there is no
change to the set of supported conditions or filters.
During configuration, the bandwidth is specified in Mbps, not in bytes/second. While creating the actual
LB extended community, the system will attach the AS number and encode the bandwidth in floating
point format.
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv4 address on the system.
Z-Series
Syntax
show capture bgp-pdu neighbor ipv4-address
Parameters
ipv4-address Enter the IPv4 address (in dotted decimal format) of the BGP address to display
packet information for that address.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
330 Border Gateway Protocol