Administrator Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To remove all configured debug commands for BGP, enter the no debug ip bgp command.
debug ip bgp soft-reconfiguration
Enable soft-reconfiguration debug.
Z9000
Syntax
debug ip bgp [A.B.C.D | X:X:X:X::X | peer-group-name] soft-reconfiguration
To disable, use the debug ip bgp [A.B.C.D | X:X:X:X::X | peer-group-name] soft-
reconfiguration command.
Parameters
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers
within the peer group..
Defaults Disabled
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging. If no neighbor is specified, debug
turns on for all neighbors.
Border Gateway Protocol 297