Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

291

292

293

294

295

296

297

298

299

300

Table Of Contents

● ^ = (caret) the beginning of the input string. If you use the caret at the

beginning of a sequence or range, it matches on everything BUT the characters

specified.

● $ = (dollar sign) the end of the output string.

Command Modes EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

Usage

Information

If you enter the clear ip bgp flap-statistics command without any parameters, all statistics

are cleared.

Commands

show debugging — views the enabled debugging operations.

show ip bgp flap-statistics — views the BGP flap statistics.

undebug all — disables all debugging operations.

clear ip bgp peer-group

Reset a peer-group’s BGP sessions.

Z9000

Syntax

clear ip bgp peer-group peer-group-name [ipv4 [multicast | unicast] | ipv6

unicast] [soft {in | out}]

Parameters

peer-group-name

Enter the peer group name to reset the BGP sessions within that peer group.

ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to

reset ipv4 multicast routes.

ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to reset

ipv4 unicast routes.

ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to reset

ipv6 unicast routes.

soft (OPTIONAL) Enter the keyword soft to reset soft configuration.

in Enter the keyword in to re-configure soft inbound updates.

out Enter the keyword out to re-configure soft outbound updates.