Administrator Guide

Distance: external 20 internal 200 local 200
Dell(conf-router_bgp)#
Related
Commands
show ip protocols — views information on all routing protocols enabled and active on the E-Series.
bgp router-id
Assign a user-given ID to a BGP router.
Z9000
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address Enter an IP address in dotted decimal format to reset only that BGP neighbor.
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback interfaces are
configured, the highest IP address of a physical interface on the router.
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
Peering sessions are reset when you change the router ID of a BGP router.
This command automatically restarts the BGP instance for the configuration to take effect.
clear ip bgp
Reset BGP sessions. The soft parameter (BGP Soft Reconfiguration) clears the policies without resetting the TCP connection.
Z9000
Syntax
clear ip bgp [* | <1–4294967295> | <0.1–65535.65535> | A.B.C.D {soft {in |
out}} | X:X:X:X::X {soft {in | out}} | dampening | flap-statistics | ipv4 |
ipv6 | peer-group]
Parameters
* Enter an asterisk ( * ) to reset all BGP sessions.
<1-4294967295> Enter <1-4294967295> to clear peers with the AS number.
Border Gateway Protocol 289