Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
6.3.1.0 Introduced
Usage
Information
The MED is a 4-byte unsigned integer value and the default behavior is to assume a missing MED as
4294967295. This command causes a missing MED to be treated as 0. During path selection, paths with a
lower MED are preferred over paths with a higher MED.
bgp bestpath router-id ignore
Do not compare router-id information for external paths during best path selection.
Z9000
Syntax
bgp bestpath router-id ignore
To return to the default selection, use the no bgp bestpath router-id ignore command.
Defaults Disabled
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced
Usage
Information
Configuring this option retains the current best-path. When sessions are then reset, the oldest received
path is chosen as the best-path.
bgp client-to-client reflection
Allows you to enable route reflection between clients in a cluster.
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the no bgp client-to-client reflection command.
Defaults Enabled when a route reflector is configured.
Border Gateway Protocol 277