Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for the 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced.
Usage
Information
show ip
accounting
access-
lists Field
Description
“Extended IP...” Displays the name of the IP ACL.
“seq 5...” Displays the filter. If the keywords count or byte were configured in the filter,
the number of packets or bytes the filter processes is displayed at the end of the
line.
“order 4” Displays the QoS order of priority for the ACL entry.
Example
Dell#show ip accounting access-list
!
Standard Ingress IP access list test on TenGigabitEthernet 0/88
Total cam count 2
seq 5 permit 1.1.1.0/24 count (0 packets)
seq 10 deny 2.1.1.0/24 count (0 packets
Standard IP ACL Commands
When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an implicit permit.
The Z9000 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
deny
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}}
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no deny {source [mask] | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the
packet was sent.
any Enter the keyword any to specify that all routes are subject to the filter. You can
enter any of the following keywords to specify route types.
● bytes — Enter the keyword count to count packets the filter processes.
152 Access Control Lists (ACL)