Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

141

142

143

144

145

146

147

148

149

150

Table Of Contents

Version Description

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names

were up to 16 characters long.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

ip access-group

Assign an IP access list (IP ACL) to an interface.

Syntax

ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-

id]

To delete an IP access-group configuration, use the no ip access-group access-list-name

{in | out} [implicit-permit] [vlan vlan-id] command.

Parameters

access-list-name

Enter the name of a configured access list, up to 140 characters.

in Enter the keyword in to apply the ACL to incoming traffic.

out Enter the keyword out to apply the ACL to outgoing traffic.

implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action

of the ACL from implicit-deny to implicit-permit (that is, if the traffic does not

match the filters in the ACL, the traffic is permitted instead of dropped).

vlan

vlan-id

(OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The

range is from 1 to 4094 (you can use IDs from 1 to 4094).

Defaults Not enabled.

Command Modes INTERFACE/VRF MODE

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.