Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

141

142

143

144

145

146

147

148

149

150

Table Of Contents

Common IP ACL Commands

The following commands are available within both Ingress and Egress IP ACL modes (Standard and Extended) and do not have

mode-specific options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an

implicit permit.

The Z9000 supports both Ingress and Egress IP ACLs.

NOTE: Also refer to the Commands Common to all ACL Types section.

access-class

Apply a standard ACL to a terminal line.

Syntax

access-class access-list-name

To remove an ACL, use the no access-class access-list-name command.

Parameters

access-list-name

Enter the name of a configured Standard ACL, up to 140 characters.

Defaults Not configured.

Command Modes LINE

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.8.1.0 Increase the name string to accept up to 140 characters. Prior to 7.8.1.0, names

were up to 16 characters long.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

clear counters ip access-group

Erase all counters maintained for access lists.

Syntax

clear counters ip access-group [access-list-name]