Administrator Guide

• seq arp (for Extended MAC ACLs)
• seq ether-type (for Extended MAC ACLs)
• seq (for IP ACLs)
• seq (for IPv6 ACLs)
• permit udp (for IPv6 ACLs)
• permit tcp (for IPv6 ACLs)
• permit icmp (for IPv6 ACLs)
• permit (for IPv6 ACLs)
• deny udp (for IPv6 ACLs)
• deny tcp (for IPv6 ACLs)
• deny icmp (for Extended IPv6 ACLs)
• deny (for IPv6 ACLs)
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specific options. Some commands in this
chapter may use similar names, but require different options to support the different ACL types (for example, the deny and
permit commands).
remark
Enter a description for an ACL entry.
Syntax
remark [remark-number] [description]
Parameters
remark-number Enter the remark number. The range is from 0 to 4294967290.
NOTE: You can use the same sequence number for the remark and an ACL
rule.
description Enter a description of up to 80 characters.
Defaults Not configured.
Command Modes
● CONFIGURATION-STANDARD-ACCESS-LIST
● CONFIGURATION-EXTENDED-ACCESS-LIST
● CONFIGURATION-MAC ACCESS LIST-STANDARD
● CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced on the E-Series.
Access Control Lists (ACL) 147