Administrator Guide

7 0
Dell#
Dell#show dot1x cos-mapping interface tengigabitethernet 1/32 mac-
address 00:00:00:00:00:10
Supplicant Mac: 0 0 0 0 0 10 Lookup for Mac:
802.1p CoS re-map table on Te 0/32:
----------------------------------
802.1p CoS re-map table for Supplicant: 00:00:00:00:00:10
Dot1p Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
Dell#
show dot1x interface
Display the 802.1X configuration of an interface.
Syntax
show dot1x interface interface [mac-address mac-address]
Parameters
interface Enter one of the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
mac-address (Optional) MAC address of a supplicant.
Defaults none
Command Modes
● EXEC
● EXEC privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.2.1 Added the mac-address option on the C-Series and S-Series.
7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Usage
Information
If you enable 802.1X multi-supplicant authentication on a port, additional 802.1X configuration details
(Port Authentication status, Untagged VLAN ID, Authentication PAE state, and Backend state) display for
each supplicant, as shown in the following example.
142 802.1X