Administrator Guide

IPv6 VRRP Commands
The following are IPv6 VRRP commands.
● clear counters vrrp ipv6
● debug vrrp ipv6
● show vrrp ipv6
● vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
● advertise-interval
●
description
● disable
● hold-time
● preempt
● priority
● show config
● virtual-address
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group. The range is from 1 to 255.
vrf vrf-name (OPTIONAL) Enter the name of a VRF instance (32 characters maximum) to clear
the counters of all IPv6 VRRP groups in the specified VRF.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support was added for
IPv6 VRRP groups in non-default VRF instances.
8.3.2.0 Introduced on the E-Series TeraScale.
debug vrrp ipv6
Allows you to enable debugging of VRRP.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state | timer}
Parameters
interface Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number.
Virtual Router Redundancy Protocol (VRRP) 1313