Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.2(0.2) Added multicast and ndp parameters.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Example
VLT ARP Statistics
----------------
ARP Tunnel Pkts sent:0
ARP Tunnel Pkts Rcvd:0
ARP-sync Pkts Sent:0
ARP-sync Pkts Rcvd:0
ARP Reg Request sent:19
ARP Reg Request rcvd:10
Related
Commands
show vlt statistics — displays statistics on VLT operations.
delay-restore
Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer switches.
Syntax
delay-restore
Parameters
delay-restore Enter the amount of time, in seconds, to delay bringing up the VLT ports after
the VLTi device is reloaded or after the peer-link is restored between VLT peer
switches. The range from 1 to 1200. The default is 90 seconds.
Defaults Not configured.
Command Modes VLT DOMAIN
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S8420T.
8.3.12.0 Introduced on the S4810.
Usage
Information
To delay the system from bringing up the VLT port for a brief period to allow IGMP Snooping and Layer 3
routing protocols to converge, use the delay-restore parameter. Use this feature:
1276 Virtual Link Trunking (VLT)