Administrator Guide

dei mark
Set the DEI value on egress according to the color currently assigned to the packet.
Z9000
Syntax
dei mark {green | yellow} {0 | 1}
Parameters
0 | 1 Enter the bit value you want to map to a color.
green | red |
yellow
Choose a color:
● Green: High priority packets that are the least preferred to be dropped.
● Yellow: Lower priority packets that are treated as best-effort.
Defaults All the packets on egress are marked with DEI 0.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Instroduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
dei enable – Make packets eligible for dropping based on their DEI value.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in
its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
Defaults Not configured.
Command Modes CONF-IF-VLAN
VLAN Stacking 1267