Administrator Guide

tunnel source
Set a source address for the tunnel.
Syntax
tunnel source {ip-address | ipv6–address | interface-type-number |
anylocal}
To delete the current tunnel source address, use the no tunnel source command.
Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
interface-type-
number
● For a port channel interface, enter the keywords port-channel then a
number from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
anylocal
Enter the anylocal command to allow the multipoint receive-only tunnel to
decapsulate tunnel packets destined to any local ip address.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the tunnel source anylocal command.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Added an optional keyword “anylocal” to the tunnel source command. The anylocal argument can be
used in place of the ip address or interface, but only with the multipoint receive-only mode tunnels. The
tunnel source anylocal command allows the multipoint receive-only tunnel to decapsulate tunnel
packets addressed to any IPv4 or IPv6 (depending on the tunnel mode) address configured on the switch
that is operationally Up.
tunnel keepalive
Configure the tunnel keepalive target, interval and attempts.
Syntax
tunnel keepalive {ip-address | ipv6-address}[interval {seconds}] [attempts
{count | unlimited}]
To disable the tunnel keepalive probes use the no tunnel keepalive command.
Parameters
ip-address ipv6
address
Enter the IPv4 or IPv6 address of the peer to which the keepalive probes
will be sent.
interval seconds
Enter the keyword interval then the interval time, in seconds, after which the
restart process to keepalive probe packets.
The range is from 5 to 255. The default is 5.
count
(OPTIONAL) Enter the keyword count to count packets processed by the filter.
The range is from 3 to 10. The default is 3.
Tunneling 1259