Administrator Guide

Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added support for IPv6 multicast addresses.
8.3.7.0 Introduced on the S4810.
6.1.1.0 Introduced on the E-Series.
ntp master <stratum>
Configure the switch as NTP Server.
Syntax
ntp master <stratum>
Parameters
ntp
master <stratum>
Enter the stratum number to identify the NTP Server's hierarchy.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.6(0.0) Introduced on the S4810, S4820T, S5000, S6000, Z9000, and Z9500.
ntp server
Configure an NTP time-serving host.
Syntax
ntp server[vrf vrf-name] {hostname | ipv4-address | ipv6-address} [key
keyid] [prefer] [version number]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF to configure a
NTP time-serving host corresponding to that VRF.
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of NTP server.
hostname Enter the hostname of the server.
key keyid (OPTIONAL) Enter the keyword key and a number as the NTP peer key. The range
is from 1 to 4294967295.
System Time and Date 1251