Administrator Guide

Example
(History)
Dell#show logging history
Syslog History Table: 1 maximum table entries,
saving level Warnings or higher
SNMP notifications not Enabled
%RPM:0:0 %CHMGR-2-LINECARDDOWN - Line card 3 down - IPC timeout
Dell#
show logging auditlog
Displays an audit log.
Syntax
show logging auditlog
Defaults none
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Example
Dell(conf)#show logging audit
Related
Commands
clear logging auditlog — clears audit log.
show logging driverlog stack-unit
Display the driver log for the specified stack member.
Syntax
show logging driverlog stack-unit unit#
Parameters
stack-unit unit# Enter the keywords stack-unit followed by the stack member ID of the switch
for which you want to display the driver log. The range is from 0 to 7.
defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Simple Network Management Protocol (SNMP) and Syslog 1211