Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1191

Table Of Contents

Parameters

view-name

Enter the name of the view (not to exceed 20 characters).

oid-tree

Enter the OID sub tree for the view (not to exceed 20 characters).

included (OPTIONAL) Enter the keyword included to include the MIB family in the view.

excluded (OPTIONAL) Enter the keyword excluded to exclude the MIB family in the view.

Defaults none

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

E-Series legacy

command

Usage

Information

The oid-tree variable is a full sub-tree starting from 1.3.6 and cannot specify the name of a sub-tree

or a MIB. The following Example configures a view named rview that allows access to all objects under

1.3.6.1.

Example

Dell# conf

Dell#(conf) snmp-server view rview 1.3.6.1 included

Commands

show running-config snmp — displays the SNMP running configuration.

snmp trap link-status

Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.

Syntax

snmp trap link-status

To disable sending link trap messages, use the no snmp trap link-status command.

Defaults Enabled.

Command Modes INTERFACE