Administrator Guide

Example
Dell#conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related
Commands
show snmp group — displays the group name, security model, view status, and storage type of each
group.
show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address traps | informs [version 1 |
2c | 3] [auth | no auth | priv] [community-string] [udp-port port-number]
[notification-type]
To remove the SNMP host, use the no snmp-server host ip-address traps | informs
[version 1 | 2c | 3] [auth | noauth | priv] [community-string] [udp-port
number] [notification-type] command.
Parameters
ip-address Enter the keyword host then the IP address of the host (configurable hosts is
limited to 16).
ipv6-address Enter the keyword host then the IPv6 address of the host in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
traps (OPTIONAL) Enter the keyword traps to send trap notifications to the specified
host. The default is traps.
informs (OPTIONAL) Enter the keyword informs to send inform notifications to the
specified host. The default is traps.
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security model then the
security model version number 1, 2c, or 3:
● Version 1 is the least secure version.
● Version 3 is the most secure of the security modes.
● Version 2c allows transmission of informs and counter 64, which allows for
integers twice the width of what is normally allowed.
The default is version 1.
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication and then
scrambling of the packet.
community-
string
Enter a text string (up to 20 characters long) as the name of the SNMP
community.
NOTE: For version 1 and version 2c security models, this string represents the
name of the SNMP community. The string can be set using this command;
however, Dell Networking OS recommends setting the community string using
the snmp-server community command before executing this command.
For version 3 security model, this string is the USM user security name.
udp-port port-
number
(OPTIONAL) Enter the keywords udp-port followed by the port number of the
remote host to use. The range is from 0 to 65535. The default is 162.
notification-type (OPTIONAL) Enter one of the following keywords for the type of trap to be sent to
the host:
Simple Network Management Protocol (SNMP) and Syslog 1187