Administrator Guide

Version Description
7.5.1.0 Introduced on the C-Series.
unknown Introduced on the E-Series.
Example
Dell#config!------command run on host connected to switch:
--------------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected to Router2.
This
is a port connected to
IF-MIB::ifAlias.134792448 = STRING:
!------command run on Dell Networkingswitch: --------------!
Dell#snmp ifmib ifalias long
!------command run on server connected to switch: --------------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected to Router2.
This
is a port connected to Router2. This is a port connected to Router2.
This is a
port connected to Router2. This is a port connected to Router2.
IF-MIB::ifAlias.134792448 = STRING:
Dell#config
snmp-server community
Configure a new community string access for SNMPv1 v2 and v3.
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-access-list-
name [ipv6 ipv6-access-list-name | access-list-name | security-name name]
| security-name name [ipv6 ipv6-access-list-name | access-list-name |
security-name name] | access-list-name [ipv6 ipv6-access-list-name |
access-list-name | security-name name]]]
To remove access to a community, use the no snmp-server community community-string
{ro | rw} [security-name name [access-list-name | ipv6 access-list-name |
access-list-name ipv6 access-list-name]] command.
Parameters
community-name Enter a text string (up to 20 characters long) to act as a password for SNMP.
ro Enter the keyword ro to specify read-only permission.
rw Enter the keyword rw to specify read-write permission.
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 then an IPv6 ACL name (a string up to 16
characters long).
security-name
name
(Optional) Enter the keywords security-name then the security name as
defined by the community MIB.
access-list-name (Optional) Enter a standard IPv4 access list name (a string up to 16 characters
long).
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Simple Network Management Protocol (SNMP) and Syslog 1181