Administrator Guide

sflow collector
Configure a collector device to which sFlow datagrams are forwarded.
Syntax
sflow collector {ip-address | ipv6-address} agent-addr {ip-address | ipv6-
address} [number [max-datagram-size number]] | [max-datagram-size number]
[vrf management]
To delete a configured collector, use the no sflow collector {ip-address | ipv6-
address} agent-addr {ipv4-address | ipv6-address} [number [max-datagram-
size number]] | [max-datagram-size number] [vrf management] command.
Parameters
sflow collector
ip-address |
ipv6-address
Enter the IP address of the collector in dotted decimal format for IPv4 or x:x:x:x::x
format for IPv6.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
agent-addr ip-
address | ipv6-
address
Enter the keyword agent-addr followed by the sFlow agent IP address in dotted
decimal format for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
number (OPTIONAL) Enter the user datagram protocol (UDP) port number. The range is
from 0 to 65535. The default is 6343.
max-datagram-
size number
(OPTIONAL) Enter the keyword max-datagram-size then the size number in bytes.
The range is from 400 to 1500. The default is 1400.
vrf management (OPTIONAL) Enter the keyword vrf followed by the keyword management
to configure the collector device corresponding to the default VRF and the
management VRF respectively.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.4.2.3 Added support for IPv6 sFlow collectors and agents on the E-series TeraScale,
C-Series, and S-Series.
8.4.1.1 Added support for IPv6 sFlow collectors and agents on the E-series ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.5.1.0 Expanded the no form of the command to mirror the syntax used to configure.
6.2.1.1 Introduced on the E-Series.
1168 sFlow