Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1111

Table Of Contents

Defaults Not configured.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Authentication key length increased to 42 characters.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre-6.2.1.0 Introduced on the E-Series.

Usage

Information

The key configured on the switch must match the key configured on the RADIUS server daemon.

If you configure the key parameter in the radius-server host command, the key configured with

the radius-server key command is the default key for all RADIUS communications.

Commands

radius-server host — configures a RADIUS host.

radius-server retransmit

Configure the number of times the switch attempts to connect with the configured RADIUS host server before declaring the

RADIUS host server unreachable.

Syntax

radius-server retransmit retries

To configure zero retransmit attempts, use the no radius-server retransmit command.

To return to the default setting, use the radius-server retransmit 3 command.

Parameters

retries

Enter a number of attempts that FTOS tries to locate a RADIUS server. The range

is from zero (0) to 100. The default is 3 retries.

Defaults 3 retries