Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1111

Table Of Contents

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre-6.2.1.0 Introduced on the E-Series.

ip radius source-interface

Specify an interface’s IP address as the source IP address for RADIUS connections.

Syntax

ip radius source-interface interface

To delete a source interface, use the no ip radius source-interface command.

Parameters

interface

Enter the following keywords and slot/port or number information:

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

● For a Loopback interface, enter the keyword loopback then a number from 0

to 16383.

● For a port channel interface, enter the keywords port-channel then a

number. The range is from 1 to 128.

● For a Null interface, enter the keyword null then the Null interface number.

●

For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults Not configured.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.