Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1061

Table Of Contents

To remove a specified RMON history group of statistics collection, use the no rmon collection

history {controlEntry integer} command.

Parameters

controlEntry

integer

Enter the keyword controlEntry to specify the RMON group of statistics using

a value. Then enter an integer value from 1 to 65535 that identifies the RMON

group of statistics. The integer value must be a unique index in the RMON history

table.

owner

name

(OPTIONAL) Enter the keyword owner then the owner name to record the owner

of the RMON group of statistics.

buckets

number

(OPTIONAL) Enter the keyword buckets then the number of buckets for the

RMON collection history group of statistics. The bucket range is from 1 to 1000.

The default is 50.

interval

seconds

(OPTIONAL) Enter the keyword interval then the number of seconds in each

polling cycle. The range is from 5 to 3600 seconds. The default is 1800 seconds.

Defaults none

Command Modes CONFIGURATION INTERFACE (config-if)

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.1.1.0 Introduced on the E-Series.

rmon collection statistics

Enable RMON MIB statistics collection on an interface.

Z9000

Syntax

rmon collection statistics {controlEntry integer} [owner name]

To remove RMON MIB statistics collection on an interface, use the no rmon collection

statistics {controlEntry integer} command.