Administrator Guide

Parameters
interface Enter the following information:
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
Although the passive interface does not send or receive routing updates, the network on that interface
still includes in RIP updates sent using other interfaces.
Related
Commands
neighbor — enables RIP for a specified network.
network — defines a neighbor.
redistribute
Redistribute information from other routing instances.
Z9000
Syntax
redistribute {connected | static}
To disable redistribution, use the no redistribute {connected | static} command.
Parameters
connected Enter the keyword connected to specify that information from active routes on
interfaces is redistributed.
static Enter the keyword static to specify that information from static routes is
redistributed.
Defaults Not configured.
Command Modes ROUTER RIP
1056 Routing Information Protocol (RIP)