Administrator Guide

Version Description
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
When the offset metric is applied to an interface, that value takes precedence over an offset value that is
not extended to an interface.
Related
Commands
ip prefix-list — enters PREFIX-LIST mode and configure a prefix list.
output-delay
Set the interpacket delay of successive packets to the same neighbor.
Z9000
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no output-delay command.
Parameters
delay Specify a number of milliseconds as the delay interval. The range is from 8 to 50.
Defaults Not configured.
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
This command is intended for low-speed interfaces.
passive-interface
Suppress routing updates on a specified interface.
Z9000
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Routing Information Protocol (RIP) 1055