Administrator Guide

vty number Enter the keyword vty then a number from 0 to 9 to configure a virtual terminal
line for remote sessions. The system supports 10 remote sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to
configure. You can configure multiple lines at one time.
Defaults Not configured
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
You cannot delete a terminal connection.
Related
Commands
access-class — restricts the incoming connections to a particular IP address in an IP access control list
(ACL).
password — specifies a password for users on terminal lines.
motd-banner
Enable a message of the day (MOTD) banner to appear when you log in to the system.
Syntax
motd-banner
To disable the MOTD banner, use the no motd-banner command.
Defaults Enabled on all lines.
Command Modes LINE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
102 Control and Monitoring