Administrator Guide

Version Description
8.3.7.0 Introduced on the S4820T.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
ip tftp vrf
Configures an TFTP client with a VRF that is used to connect to the TFTP server.
Syntax
ip tftp [vrf vrf-name]
To undo the TFTP client configuration, use the no ip tftp [vrf vrf-name] command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to specify the VRF that is
used by the TFTP client.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage
Information
Use this command to make the TFTP clients VRF aware. The VRF name that you specify is used by the
TFTP client to reach the TFTP server. If no VRF is specified, then the default VRF is used.
Related
Commands
ftp-server topdir — sets the directory to be used for incoming FTP connections.
ftp-server username — sets a username and password for incoming FTP connections.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set
the access conditions for the designated line.
Syntax
line {aux 0 |console 0 | vty number [end-number]}
Parameters
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal connection.
console 0 Enter the keyword console 0 to configure the console port. The console option
for the S-Series is <0-0>.
Control and Monitoring 101