Users Guide

Parameters
events Enter the keyword events to enable debugging of FEFD state changes.
packets Enter the keyword packets to enable debugging of FEFD to view information on
packets sent and received.
interface (OPTIONAL) Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
Legacy E-Series
command.
Related
Commands
● fefd — enable far-end failure detection on an interface.
● fefd reset — enable FEFD globally on the system.
fefd
Enable Far-End Failure Detection on an interface, set the FEFD interval, or select the FEFD mode.
Syntax
fefd {disable|interval|mode {aggressive|normal}
Parameters
disable Enter the keyword disable to disable FEFD for the specified interface.
interval Enter the keyword interval, followed by a value to specify the FEFD interval in
seconds. Range is from 3 to 300. Default is 15.
mode Enter the keyword mode followed by the mode type to specify the FEFD mode.
Layer 2 915