Users Guide

version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security model then the
security model version number 1, 2c, or 3:
● Version 1 is the least secure version.
● Version 3 is the most secure of the security modes.
● Version 2c allows transmission of informs and counter 64, which allows for
integers twice the width of what is normally allowed.
The default is version 1.
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication and then
scrambling of the packet.
community-
string
Enter a text string (up to 20 characters long) as the name of the SNMP
community.
NOTE: For version 1 and version 2c security models, this string represents the
name of the SNMP community. The string can be set using this command;
however, Dell EMC Networking OS recommends setting the community string
using the snmp-server community command before executing this
command. For version 3 security model, this string is the USM user security
name.
udp-port port-
number
(OPTIONAL) Enter the keywords udp-port followed by the port number of the
remote host to use. The range is from 0 to 65535. The default is 162.
notification-type (OPTIONAL) Enter one of the following keywords for the type of trap to be sent to
the host:
● bgp — Enable BGP state change traps.
● ecfm — Enable ECFM state change traps.
● entity — Enable entity change traps.
● envmon — Enable SNMP environmental monitor traps.
● eoam — Enable EOAM state change traps
● ets — Enable ets traps
● fips — Enable FIP Snooping state change traps
● lacp — Enable LACP state change traps.
● mac — Enable MAC address notification traps.
● isis — Enable ISIS adjacency change traps.
● pfc — Enable pfc traps.
● snmp — Enable SNMP trap.
● stp — Enable 802.1d state change traps.
● vlt — Enable VLT traps.
● vrrp — Enable VRRP state change traps.
● xstp — Enable 802.1s, 802.1w, and PVST+ state change traps.
The default is all trap types are sent to host.
Defaults As above.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced MAC address notification traps on all the Dell EMC Networking OS
platforms.
Simple Network Management Protocol (SNMP) and Syslog 1485