Users Guide

● For a Tunnel interface, enter the keyword tunnel then a number from 1 to
16383.
tos (IPv4 only) Enter the type of service required. The range is from 0 to 255. The
default is 0.
df-bit (IPv4 only) Enter Y or N for the “don't fragment” bit in IPv4 header.
● N: Do not set the “don't fragment” bit.
● Y: Do set “don't fragment” bit
Default is No.
validate-reply (IPv4 only) Enter Y or N for reply validation.
● N: Do not validate reply data.
● Y: Do validate reply data.
Default is No.
outgoing-
interface
(IPv6 link-local address) Enter the outgoing interface for ping packets to a
destination link-local address.
pattern pattern (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF. Default: 0xABCD.
sweep-min-size Enter the minimum size of datagram in sweep range. The range is from 52 to 15359
bytes.
sweep-max-size Enter the maximum size of datagram in sweep range. The range is from 53 to
15359 bytes.
sweep-interval Enter the incremental value for sweep size. The range is from 1 to 15308 seconds.
interface (IPv4 only) Enter the outgoing interface for multicast packets. Enter the IP address
in A.B.C.D format.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
ethernet Enter the keyword ethernet to test layer2 connectivity.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to test connectivity to
the VRF.
Defaults None.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
116 Control and Monitoring