Users Guide

● If the scaled metric for a route is greater than or equal to the DOWN threshold or the route is not
entered in the routing table, the state of a route is DOWN.
You configure the UP and DOWN thresholds for each tracked route by using the threshold metric
command. The default UP threshold is 254; the default DOWN threshold is 255. The notification of a
change in the state of a tracked object is sent when a metric value crosses a configured threshold.
Related
Commands
● show track – display information about tracked objects, including configuration, current state, and
clients which track the object.
● threshold metric – configure the metric threshold used to determine the UP and/or DOWN state of a
tracked route.
● track resolution ip route – configure the protocol-specific resolution value used to scale an IPv4 route
metric.
track ip route reachability
Configure object tracking on the reachability of an IPv4 route.
Syntax
track object-id ip route ip-address/prefix-len reachability [vrf vrf-name]
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to 500.
ip-address/
prefix-len
Enter an IPv4 address in dotted decimal format. The valid IPv4 prefix lengths are
from /0 to /32.
vrf vrf-name (Optional) E-Series only: You can configure a VPN routing and forwarding (VRF)
instance to specify the virtual routing table to which the tracked route belongs.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage
Information
Use this command to create an object that tracks the reachability of an IPv4 route. In order for a route’s
reachability to be tracked, the route must appear as an entry in the routing table.
A tracked IPv4 route is considered to match an entry in the routing table only if the exact IPv4 address
and prefix length match a table entry. For example, when configured as a tracked route, 10.0.0.0/24 does
not match the routing table entry 10.0.0.0/8. If no route-table entry has the exact IPv4 address and
prefix length, the status of the tracked route is considered to be DOWN.
Object Tracking 1035