Setup Guide

● Egress port for unfragmented packets.
● In the event of fragmented packets, the egress port of the first fragment.
● In the event of fragmented packets, the egress port of the subsequent fragments.
NOTE: In the show port channel flow command output, the egress port for an unknown
unicast, multicast, or broadcast traffic is not displayed.
The following example shows the show port-channel-flow outgoing-port-channel number
incoming-interface interface source-mac address destination-mac address
● Load-balance is configured for MAC
● Load-balance is configured for IP 4-tuple/2-tuple
● A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address
Example
DellEMC# show port-channel-flow outgoing-port-channel 1 incoming-
interface te 3/3
source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00
Egress Port for port-channel 1, for the given flow, is Te 13/2
ip http source-interface
Specify an interface as the source interface for HTTP connections.
Syntax
ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
726 Interfaces