Setup Guide

Table Of Contents
This command fails if the address family entered does not match the outer header address family of the
tunnel mode, tunnel source, or any other tunnel allow-remote.
If you configure any allow-remote , the tunnel source or tunnel mode commands fail if the outer header
address family does not match that of the configured allow-remote.
Usage
Information
Allow-remote entries can be configured only on multipoint receive-only tunnels, that is tunnel mode
includes decapsulate-any option. This command will fail if any bidirectional tunnel options are configured.
Likewise, attempts to configure bidirectional tunnel options will fail if any allow-remote entries are
configured.
tunnel destination
Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6address}
To delete a tunnel destination address, use the no tunnel destination {ip-address | ipv6
address} command.
Parameters
ip-address
Enter the destination IPv4 address for the tunnel.
ipv6address
Enter the destination IPv6 address for the tunnel.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Usage
Information
The tunnel interface is inoperable without a valid tunnel destination address for the configured Tunnel
mode.
To establish a logical tunnel to the particular destination address, use the destination address of the
outer tunnel header. If you configure a tunnel interface or source address, the tunnel destination must be
compatible.
1578 Tunneling