Setup Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
6.1.1.1 Introduced on the E-Series.
Usage
Information
To configure the minimum and maximum threshold values for user-defined profiles, use this command.
Additionally, to modify the minimum and maximum threshold values for the pre-defined WRED profiles,
use this command. If you delete the threshold values of the pre-defined WRED profiles, the profiles revert
to their original default values.
Table 5. Threshold Values for the Pre-defined WRED Profiles
Pre-Defined WRED Profile
Name
Minimum Threshold Maximum
Threshold
Maximum Drop
Rate
wred_drop 0 0 100
wred_teng_y 594 5941 100
wred_teng_g 594 5941 50
wred_fortyg_y 594 5941 50
wred_fortyg_g 594 5941 25
Related
Commands
● wred-profile — creates a WRED profile.
trust
Specify dynamic classification (DSCP) or dot1p to trust.
S6000
Syntax
trust {diffserv [fallback]| dot1p [fallback]}
Parameters
diffserv Enter the keyword diffserv to specify trust of DSCP markings.
dot1p Enter the keyword dot1p to specify trust dot1p configuration.
fallback Enter the keyword fallback to classify packets according to their DSCP or dot1p
value as a secondary option in case no match occurs against the configured class
maps.
Defaults none
Command Modes CONFIGURATION (conf-policy-map-in)
Quality of Service (QoS) 1243