Service Manual

mappings are identical. This section discusses the Dell EMC Networking OS configurations needed for above PFC generation
and honoring mechanism to work for the untagged packets.
PRIORITY to PG mapping (PRIO2PG) is on the ingress for each port. By default, all priorities are mapped to PG7. A priority for
which PFC has to be generated is assigned to a PG other than PG7 (say PG6) and buffer watermark is set on PG6 so as to
generate PFC.
In ingress, the buffers are accounted at per PG basis and would indicate the number of the packets that has ingress this port
PG but still queued up in egress pipeline. However, there is no direct mapping between the PG and Queue.
Packet is assigned an internal priority on the ingress pipeline based on the queue to which it is destined. This Internal-priority to
Queue mapping has been modified and enhanced as follows for the device:
Table 22. Priority to Queue Mapping
Dot1p Priority Queue
0 1
1 0
2 2
3 3
4 4
5 5
6 6
7 7
Default dot1p to queue configuration is as follows:
Configuration Example for DSCP and PFC Priorities
Consider a scenario in which the following DSCP and PFC priorities are necessary:
DSCP
0 – 5, 10 - 15 20 – 25, 30 – 35
Expected PFC
Priority
1 2
To configure the aforementioned DSCP and PFC priority values, perform the following tasks:
1. Create class-maps to group the DSCP subsets
class-map match-any dscp-pfc-1
match ip dscp 0-5,10-15
!
class-map match-any dscp-pfc-2
match ip dscp 20-25,30-35
2. Associate above class-maps to Queues Queue assignment as below.
DellEMC(conf)#do show qos dot1p-queue-mapping
Dot1p Priority : 0 1 2 3 4 5 6 7
Queue : 1 0 2 3 4 5 6 7
3. Dot1p->Queue Mapping Configuration is retained at the default value.
4. Interface Configurations on server connected ports.
a. Enable DCB globally.
DellEMC(conf)#dcb enable
268
Data Center Bridging (DCB)