Release Notes
Table Of Contents
- Dell EMC System S3048–ON 9.14(2.10) Release Notes
- Document Revision History
- Supported Hardware
- Supported Software
- New Dell EMC Networking OS Version 9.14(2.10) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading ONIE on the S3048-ON
- Installing Dell EMC Networking OS on the S3048-ON using ONIE
- Upgrading the S3048-ON Dell EMC Networking OS Image using the Dell EMC Networking OS CLI
- Uninstalling Dell EMC Networking OS on the S3048-ON
- Installing a Third Party Operating System
- Support Resources
Supported Hardware
The following hardware is supported with this platform:
Hardware
S3048-ON chassis
Forty-eight 10/100/1000Base-T RJ-45 Ports
Four SFP+ optical ports (10 Gbps)
Management Port
USB 2.0 Port
Serial Console Port
Two AC PSUs
Three fan subsytems
NOTE: If all the three fan trays are found to be empty or faulty, the system shuts down after one minute.
Supported Software
The following software is supported with this platform:
Software
Minimum Release Requirement
Dell EMC Networking OS 9.14(2.10)
ONIE
3.24.1.0-4
NOTE: For information on non-Dell OS versions, refer the Release Notes for the Hardware Platform S3048–ON.
New Dell EMC Networking OS Version 9.14(2.10)
Features
The following features are integrated into the Dell EMC Networking 9.14.2 branch through this release:
None
Restrictions
● Prerequisite steps to upgrade the Dell EMC Networking OS from earlier version to 9.14.2.0 or later:
1. Uninstall the older version of the Open Automation (OA) package
2. Upgrade the Dell EMC Networking OS to 9.14.2.0 or later version
3. Install the following OA packages from the respective upgraded version:
a. SmartScripts
b. Puppet
c. Open management infrastructure (OMI)
d. SNMP MIB
2