Release Notes

stack-unit 1 DOWNLOAD BOOT 9.14(2.10)[boot] 9.14(2.9)
stack-unit 2 is not present.
stack-unit 3 is not present.
stack-unit 4 is not present.
stack-unit 5 is not present.
stack-unit 6 is not present.
DellEMC#
DellEMC#
4. Change the Primary Boot Parameter of the S3048-ON to the upgraded partition A: or B:
CONFIGURATION
boot system stack-unit 1 primary system: [A: | B: | tftp: | ftp:]
5. Save the configuration so that the configuration will be retained after a reload using write memory command.
EXEC Privilege
write memory
DellEMC#write memory
!
May 10 18:58:59: %STKUNIT1-M:CP %FILEMGR-5-FILESAVED: Copied running-config to
startup-config in flash by default
DellEMC#
6. Reload the unit.
EXEC Privilege
reload
Command : reload
Mode : EXEC PRIVILEGE
DellEMC#reload
Proceed with reload [confirm yes/no]: y
7. Verify the S3048 ON has been upgraded to the Dell EMC Networking OS version 9.14(2.10).
EXEC Privilege
show version
DellEMC#show version
Dell EMC Real Time Operating System Software
Dell EMC Operating System Version: 2.0
Dell EMC Application Software Version: 9.14(2.10)
Copyright (c) 1999-2021 by Dell EMC Inc. All Rights Reserved.
Build Time: Tue May 18 10:20:04 2021
Build Path: /build/build01/SW/SRC
Dell EMC Networking OS uptime is 3 day(s), 21 hour(s), 3 minute(s)
System image file is "system://A"
System Type: S3048-ON
Control Processor: Intel Rangeley with 2 Gbytes (2127654912 bytes) of memory, core(s)
2.
8G bytes of boot flash memory.
1 52-port GE/TE (SG-ON)
48 GigabitEthernet/IEEE 802.3 interface(s)
4 Ten GigabitEthernet/IEEE 802.3 interface(s)
DellEMC#
Uninstalling Dell EMC Networking OS on the S3048-ON
To uninstall the Dell EMC Networking OS version 9.14(2.10) from the S3048-ON device, perform the following steps:
15