Release Notes
Table Of Contents
- Dell EMC System S3048–ON 9.14(2.10) Release Notes
- Document Revision History
- Supported Hardware
- Supported Software
- New Dell EMC Networking OS Version 9.14(2.10) Features
- Restrictions
- Changes to Default Behavior and CLI Syntax
- Documentation Corrections
- Deferred Issues
- Fixed Issues
- Known Issues
- Upgrading the sub-components
- Upgrading ONIE on the S3048-ON
- Installing Dell EMC Networking OS on the S3048-ON using ONIE
- Upgrading the S3048-ON Dell EMC Networking OS Image using the Dell EMC Networking OS CLI
- Uninstalling Dell EMC Networking OS on the S3048-ON
- Installing a Third Party Operating System
- Support Resources
machine restart
BIOS (Dell EMC Inc) Boot Selector
S3000 3.24.0.0-11
(48-port 1G/4-port SFP+ 10G)
CPLD JTAG to normal mode... done.
Resetting...
Installing Dell EMC Networking OS on the S3048-ON
using ONIE
NOTE: The Dell EMC Networking OS installer package, ONIE-FTOS-SG-ON-9.14.2.10.bin, is required for installing Dell EMC
Networking OS on S3048-ON that has only ONIE.
To install the Dell EMC Networking OS version 9.14(2.10) on to the new S3048-ON device, perform the following steps:
1. Boot the system to the ONIE prompt.The following ONIE prompt appears:
ONIE:/ #
2. Stop the ONIE discovery process using the following command:
ONIE:/ # onie-discovery-stop
The following message appears:
Stopping: discover... done.
ONIE:/ #
3. Configure an interface and assign an IP address to that interface using the following command:
ONIE:/ # ifconfig eth0 ip-address/prefix up
4. Enter the following command to begin the installation process:
ONIE:/ # onie-nos-install tftp://10.16.127.35/ONIE-FTOS-SG-ON-9.14.2.10.bin
NOTE: After the Dell EMC Networking OS installation is complete, the system automatically reboots.
Following is the installation and boot log of Dell EMC Networking OS:
ONIE:/ #
ONIE:/ #
ONIE:/ # onie-nos-install tftp://10.16.127.35/ONIE-FTOS-SG-9.14.2.10.bin
Stopping: discover... done.
Info: Fetching tftp://10.16.127.35/ONIE-FTOS-SG-9.14.2.10.bin ...
ONIE-FTOS-SG-9.14.2.10 100% |*******************************| 95426k 0:00:00 ETA
ONIE: Executing installer: tftp://10.16.127.35/ONIE-FTOS-SG-
.2.7.bin
Verifying image checksum ... OK.
Preparing image archive from /installer ... Done.
Verifying Product Platform...
Image File : ONIE-FTOS-SG-9.14.2.10.bin
Product Name : S3048-ON
Platform Verified : OK
Deleting Extra partitions... Done.
Creating New partitions... Done.
Creating Hybrid MBR... Done.
Mouting /dev/sda4,/dev/sda5 and /dev/sda6... Done.
Installing GRUB on /dev/sda4...Done.
Copying Images... Done.
ONIE:/ # umount: can't remount rootfs read-only
The system is going down NOW!
Sent SIGTERM to all processes
Sent SIGKILL tosd 0:0:0:0: [sda] Synchronizing SCSI cache
12